->

INDIANANGLER

India fishing forum for all the information you require on angling, equipment, locations and trip reports.
It is currently Thu Oct 29, 2020 7:08 am

All times are UTC+05:30


Forum rules





Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Jun 13, 2012 3:07 pm 
Offline
Fishaholic
User avatar

Joined: Fri Jul 18, 2008 3:26 pm
Posts: 243
While trolling & fishing from the beach, i always faced a snagging problem while using 8m deep diver lures, I had inadvertently bought a few years back. After losing many, I was one day taking a look at the Halco Sorcerer lures, when I realised that you could easily remove the plastic deep diver lip by knocking out the plastic locking pin (knock sideways out , 90 degrees to the lure body). Once removed, I replaced this with the 2m shallow diver lip (supplied with the lure) & PRESTO ,I had a 2m shallow diver.

A few pointers, for knocking out the plastic locking pins use a rectangular punch /drift with a blunt end. This is to ensure that the tool being used to knock out the plastic locking pin does not dig into the pin & damage it.

Secondly, at times the replacement lip is too tight & will need a little sanding to push it in.

Regards
Cavalier.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+05:30


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited