OK, this is for your reference..
I am posting the feeder rig setup photo here. It is very easy to make. The center part is empty pen refill and wound around it is one G.I. wire. In the front part, I have attached one rubber tube (Used for valve inside cycle tubes) and one end of the swill is inserted inside this tube so as if the feeder rig get snagged somewhere, when the fish is dragging it, the swill will come out of the tube and line will run free through the refill tube. As you can see, I am using one pop up set up and one free setup and I have caught all big fishes on the pop up set up.
You just have to make a ball of your bait around the wire and the pop up cork/ hook and cast it on your chosen spot. Do not forget to keep your reel on bait runner other wise you will lose your rod.
PS,. This is a copy from my old post, when I was experimenting with this rig, and I strongly recommend use of only one hook now. Using two hook setup is not fish safe and chances of fish de hooking, in case other hook get snagged is very high.